Need A Quote- Looking for MN Machinist to make 2x control panels

[Zero Cool]

Looking for a machinist in or near the Metro Minnesota area that can make two panels for my new CNC motor controller box. rear panel with several cutouts for round, square and D-Sub type connectors. Front panel with round and square holes for switches, controls, meters etc. Panels approx 17" wide and 5" high made from thin aluminum stock.

I am on a low budget but might be able to exchange services if you need electronics work etc.

Can supply AutoCAD drawings if needed. I can hack and slash with a dremel tool and drill bits but i am looking for something a bit nicer looking.

Zc

[PMD]

Originally Posted by Zero Cool Looking for a machinist in or near the Metro Minnesota area that can make two panels for my new CNC motor controller box. rear panel with several cutouts for round, square and D-Sub type connectors. Front panel with round and square holes for switches, controls, meters etc. Panels approx 17" wide and 5" high made from thin aluminum stock. I am on a low budget but might be able to exchange services if you need electronics work etc. Can supply AutoCAD drawings if needed. I can hack and slash with a dremel tool and drill bits but i am looking for something a bit nicer looking. Zc

How small is your budget?

[universalfab]

PM Sent