Need A Quote- Turned Prototypes

[ABone]

I am looking for a quote for 10 and 20 turnings of the below design. The material for the job is 6061 Al.

This is not shown in the attached file but I would also like the center hole in the design tapped to 4m x .07mm thread. If you cannot tap for metric then tapping 3/16 thread will be acceptable.

Tolerance is ±.005" and I would like these to be completed by the end of next month.

[mactec54]

ABone

Can you do your files in PDF

[Cartel, LLC]

i cant seem to open a .ipt file. pdf please.

[weller machine]

I would like to quote but need a pdf file for prints
Dave

[universalfab]

Same here...

[ABone]

Here is the pdf. The design is a bit complicated so the drawing is riddled with measurements if there is anything else I can post to help you make a quote please tell me.

[weller machine]

sorry do not have that type of capability with my present machines.
have only manual machines. I would like to put in quotes for you.
I'm a one man shop with very low overhead.
My e-mail mfg_by_weller@yahoo.com ph. 651-764-1750
Dave weller

ps I do work for different companys all over the country
distance does not seem to be a problem for me at all.
just need to always have prints in pdf.

[clemmie21710]

If you could supply a dxf in addition to the pdf that would be great. We are a job shop in Rockville Md. WE have CNC lathe and milling centers plus manual machines. We can also tap with the required threads you speak of.Thanks for the opportunity.

Regards.
Dave Clem
CNC Programmer/Machinist
Hal-Pro Inc.
Rockville Md.
301-762-1223

[ABone]

Here is the dxf you asked for.

[clemmie21710]

I am sorry to due this but could you sen the file in PDF format. This is the format that Bob my boss and owner uses to quote by. I apologize for the extra steps. Thank you for the opportunity to quote. You may send them to halpro@halpro.net attn: Bob King.

Dave.

[ABone]

I sent the pdf as you asked and I don't mind the extra email here and there.