| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Employment Opportunity Looking for a job in the machining field, need a employee in the CNC field post it here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-22-2010, 11:51 PM
| |||
| |||
Hello, I have some parts that need a couple deep holes produced. Each of the parts has three holes, approx 0.157" diameter (depths are 3", 4", and 7"). Surface finish is not relevant at all, but the runout has to be contained pretty tightly compared to what a drill could do. I'm not too experienced in sinker EDM tech but given that the holes can't be allowed to run too far out, I figured this might be a good EDM application. In terms of quantity, at this stage I only need four of the parts made. Later on it'll probably turn into a production job in which case there'd be several hundred per run. Anyway, if you'd like to quote the job I can provide any additional info. Feel free to post, PM, or e-mail at ydna@zdspb.com.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Just IN- G83 deep hole drilling | mike852 | CNCzone Club House | 2 | 02-08-2010 12:34 PM |
| deep hole threading | tequlia | General Metalwork Discussion | 9 | 02-04-2010 05:27 PM |
| Deep hole drilling | kalmah | General Metalwork Discussion | 8 | 09-09-2007 10:09 AM |
| small, deep aluminum hole | Hoeken | General Metalwork Discussion | 5 | 04-27-2007 05:52 PM |
| Deep hole drilling on OKK | eddie | G-Code Programing | 1 | 09-21-2005 06:55 PM |
| | |
Linear Mode
