RFQ: Lathe work, Very simple but needed fast

[cjd7734]

Hello, My name is Calvin
I am an artist and I have a project that I need to complete with a very short deadline

I need to get several ring blanks turned in the next few days

These are very simple but I need the quickly

Basically I need a piece of 316 stainless rod bored out to and Id of .86” with a wall thickness of .12”
Then I need rings part off at ¼ and 3/8

I also need the same process done with smaller size .66 id and .105 wall thickness
Parted at 3/16 and ¼

I would like at least 2 of each size

If you think this is feasible please let me know
If you need more information please do not hesitate to contact me


Thank you
Calvin Domenico

[MOTOXDUDE]

i could run these today. email me at ron@sutter.com

Originally Posted by cjd7734 Hello, My name is Calvin I am an artist and I have a project that I need to complete with a very short deadline I need to get several ring blanks turned in the next few days These are very simple but I need the quickly Basically I need a piece of 316 stainless rod bored out to and Id of .86” with a wall thickness of .12” Then I need rings part off at ¼ and 3/8 I also need the same process done with smaller size .66 id and .105 wall thickness Parted at 3/16 and ¼ I would like at least 2 of each size If you think this is feasible please let me know If you need more information please do not hesitate to contact me Thank you Calvin Domenico