Looking for cost of anodize

[citizencnc]

Hi,
I'm trying to bid a job and need to find out the cost of "Red anodize" and lead time to put on the quote.
I'm looking at 1000 to 10000 parts per order, parts are make out of 7075 T65 with 7/16 OD X 1/4 ID X 1/4 overall length.
At this point there is no commitment, All I want is the cost of doing 1000 pcs, 5000 pcs and 10000 pcs , I will put a RFQ here if I end up with the job.
I just want this done in the US due to lead-time. Also it’s would be great if I can get someone close by Michigan.
Thank you for your help.

[MBG]

I would like to participate in this quote.

I am assuming you want mil-8625 type II class 2.

What finish would you like?

[citizencnc]

MBG, thanks for participate.
Customer want matte finish, color could be Bordeaux R, Deep red L. They are not very picky about the finish. Their main goal is cost saving.

[MBG]

Originally Posted by citizencnc MBG, thanks for participate. Customer want matte finish, color could be Bordeaux R, Deep red L. They are not very picky about the finish. Their main goal is cost saving.

You been looking at the USSC color charts.

I stock bordeaux R.

What is the application? The lightfastness is not recommended for outdoors application. (I know this could make or break me getting the job but I just want to be honest with you)

Also, I am in tampa,fl if that is okay.

[citizencnc]

I'm sure you know much more than me about anodize and its application to tell you the truth. These parts are for some sort of paintball gun as far as I know. I will take any recommendation from you the Guru.
It's OK if you are in FL.

[MBG]

Originally Posted by citizencnc I'm sure you know much more than me about anodize and its application to tell you the truth. These parts are for some sort of paintball gun as far as I know. I will take any recommendation from you the Guru. It's OK if you are in FL.

I won't take credit being a guru that is for sure.


Also, I have much experience in paintball guns from custom work to production work.

I will take this to PM.