| |
|
#1
 
02-02-2010, 04:09 PM
| |||
| |||
I just acquired a Emco F1 CNC mill from a local school. It is in good condition, powers on and all the axis move. I do not have any tool holders with it, where can I get them? I do not have any operating manuals, where can I get them? Thank you!  |
|
#3
02-02-2010, 04:23 PM
| ||||
| ||||
DNR has the tool holder pull stud. http://tinyurl.com/ydqc5k4 http://www.dnrmfg.com/page3.htm Give them a call. I believe any 30 taper holder will work. Jeff...
__________________ Patience and perseverance have a magical effect before which difficulties disappear and obstacles vanish. |
|
#4
02-03-2010, 09:44 AM
| |||
| |||
| |
 |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- EMCO Compact 5 CNC CPU board needed. | dfstrasser | Mini Lathe | 0 | 09-17-2008 10:01 PM |
| I need some help with an Emco PC Mill 125 | Cinci_State_01 | Benchtop Machines | 2 | 05-05-2008 09:13 PM |
| Help needed - Emco F1 CNC Mill. | Edward Perera | General CNC (Mill and Lathe) Control Software (NC) | 2 | 04-24-2007 06:40 AM |
| EMCO v10 lathe help needed | flht1997 | General Metal Working Machines | 3 | 02-07-2007 09:23 AM |
| EMCO Compact5 CNC help needed. | ESjaavik | General Metal Working Machines | 5 | 07-15-2005 01:08 PM |
| | |
Emco F1 mill help needed 
Linear Mode
