EMCO-Fanuc Controller PC-keyboards wanted! - CNCzone.com-The Largest Machinist Community on the net!

kaktus-martin · #1 09-26-2009, 02:11 PM

Hi!
I´m searching for two EMCO-Fanuc controller keyboards!
Anybody here who has one or two for sale,ma from a retrofitted machine?
All offers are very welcome!
Thanks and best regards,Martin

mactec54 · #2 09-27-2009, 10:29 AM

Hi Martin

Here is a photo of one I have that would work the whole front panel is available with cables

idtkid · #3 09-27-2009, 11:13 AM

/\ Out of curiousity what is that machine? PC Mill 1XX?

mactec54 · #4 09-27-2009, 11:27 AM

Hi idtkid

PC120 Lathe just 2 cables for hook up one to the dongle board & one to the small power transformer which is 230V the monitor/crt is seperate which goes to your computer

kaktus-martin · #5 09-27-2009, 12:03 PM

I need the boards for a EMCO PC mill 50 and a EMCO PC turn 50,so I´m not sure,if the board at the picture will work.
But,may,my problem is solved,I´ve found a guy,wo is willing to sell his boards.
Thanks and best regards,Martin

mactec54 · #6 09-27-2009, 12:10 PM

Hi Martin

Yes it will work it uses the same dongle board, I'm glad you found some PC50 parts

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Emco MC 90 router information wanted	LN-JET	Commercial CNC Wood Routers	0	01-20-2009 03:45 PM
HELP WANTED WITH FANUC O-MC CONTROLLER !	r.davies	Fanuc	1	11-09-2008 10:52 AM
emco f1 to pc controller	sped1111	General Metal Working Machines	4	05-08-2008 03:01 AM
controller for small cnc mill + motor swap (emco f1)	slow_rider	Benchtop Machines	2	02-21-2008 09:19 PM
Rubber CNC Keyboards	azsigns	General Metal Working Machines	1	03-24-2004 01:37 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)