Parting TM02 Control from Emcoturn 140/240

[Marty_Escarcega]

I am going to upgrade the control so I am parting out the original TM02 control. It is missing the video board and the keyboard. Also selling the original 5 phase stepper motors as well as the stepper driver boards. I also have the 240/380V 10KVA Transformer that will be sold. Spindle motor is also available.
Contact me directly if interested in any of these parts. Here are pictures of the machine:
https://picasaweb.google.com/marty.e...ga/Emcoturn240

Hope this was ok to post here.
Marty
Mesa, AZ
escarcegaATcoxDOTnet

[nicholsmarlon12]

hi marty i have a emco 220 with tm 2 control wanted to see if any parts are the same and also if you run it on regular 3 phase power or a phase conveter i have a american rotary converter with digatal switching and the 380 transformer but spindle alarms out i think it gets a voltage over reading any suggestions thank you nichols marlon 12

[Marty_Escarcega]

hi marty i have a emco 220 with tm 2 control wanted to see if any parts are the same and also if you run it on regular 3 phase power or a phase conveter i have a american rotary converter with digatal switching and the 380 transformer but spindle alarms out i think it gets a voltage over reading any suggestions thank you nichols marlon 12

I can't tell you for sure if the parts will interchange. Possibly. I would check the voltage output of that rotary converter. It might have one leg too high. Be careful, you don't want to damage that control.....