| |
|
#1
 
08-09-2011, 08:25 AM
| |||
| |||
am having a strange error with my Emco 325 with a Fanuc 0-T control When I run a program we get a 1024 and 1029 alarm. The 1029 is a parity monitoring alarm (not in manual), the 1024 is a tool monitoring error. Emco thinks it is a turret alarm..BUT the turret seems to be turning fine, the tool goes into correct position. . Any help would be GREATLY appreciated  |
 |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Strange issue with a C10 BOB | Brass_Machine | Automation Technology Products | 1 | 04-26-2011 06:32 PM |
| EMCO PCTurn55 and EMCO PCMill50 | lutiana | General CNC (Mill and Lathe) Control Software (NC) | 2 | 10-05-2009 09:05 PM |
| Strange MAzatrol / EIA-ISO issue | SPE_user1 | Mazak, Mitsubishi, Mazatrol | 3 | 09-09-2008 08:10 AM |
| Strange serial comms issue | TLSupper | Machine Problems, Solutions , Wireless DNC, serial port | 2 | 09-27-2007 01:00 PM |
| Help with selector switch wiring issue (***actually a motor issue***) | BEDFORD | Industrial Hobbies (Support forum) | 7 | 04-07-2006 03:19 PM |
| | |
Linear Mode
