| |
|
#1
 
04-24-2011, 11:12 AM
| |||
| |||
Hi, I still have an Emco 340 built 1.986 with its original Sinnumerik control. I am getting repeatedly Alarm 13, checksum error in Z axis. The hydraulic unit will not even start because of this alarm. Both the Z axis servo and driver appear to be o.k. Any ideas what could be going on?  |
 |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem- (ALARM 414 SERVO ALARM) Y-AXIS DETECT ERROR? | PICMAN | Fanuc | 8 | 01-19-2011 01:10 PM |
| Alarm 409-servo alarm- z axis torque alm | jessebpm | Hyundai Kia machine | 3 | 06-14-2010 07:45 PM |
| ALARM shuttle drawbar alarm haas | timmydabull | Haas Mills | 27 | 10-30-2009 08:27 PM |
| EMCO PCTurn55 and EMCO PCMill50 | lutiana | General CNC (Mill and Lathe) Control Software (NC) | 2 | 10-05-2009 09:05 PM |
| Need Help!- DAEWOO 8 Steady rest pressure alarm, External feed hold alarm | doubleeagle | Daewoo/Doosan | 4 | 06-12-2009 03:15 PM |
| | |
Linear Mode
