| |
|
#1
 
07-14-2010, 02:24 PM
| |||
| |||
Hey guys, I'm new to this forum and I had a few questions for you guys. I have a EMCO PC Turn and I'm trying to use the controller that it comes with. Now what I was thinking of doing is to use LabVIEW to transfer code to the EMCO. Has anybody done anything similar? All I have right now is an old PC that I found that had the RS485 interface and I have tried the software that it comes with, but every time I turn this thing on it gives me a Y-axis error even though this is a lathe and not a mill. Thank you  |
|
#3
02-02-2012, 03:27 PM
| |||
| |||
| hello friends. i bougth an used emco pc turn 50, i have a compatible computer, but the installation disc are broken, anybony can help me to find the correct software to make work my turn... thaks ... |
 |
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- Outside jaws for EMCO PC Turn 50 | thirty78 | Benchtop Machines | 2 | 02-02-2012 03:31 PM |
| EMCO PC Turn 50 Lathe | heli_madken | EMCO CNC machines | 8 | 02-02-2012 03:28 PM |
| Emco PC turn 120 | spankyky | EMCO CNC machines | 1 | 06-25-2010 08:09 PM |
| Need Help!- Emco Turn 320 | J_Copeland | Want To Buy...Need help! | 0 | 10-21-2008 11:26 AM |
| Need Help!- EMCO PC Turn 55 | CatBurke | General CNC (Mill and Lathe) Control Software (NC) | 1 | 10-09-2008 02:21 PM |
| | |
Linear Mode
