EMCO VMC 100 MILL X-axis limit switches

[darenfs]

Hi everyone!

I changed the belt on the X-axis stepper motor. I did not mark the position of the axis pulley. Now the Emcotronics TM01 keeps running past the end position of the x-axis.
I messed up the limit switch positions. I emailed Emco in austria. Do you have any handy information on how to setup the sensors (2 limit switches: one on the X-axis pulley and the second one on the back side of the axis) on the x-axis following a belt change ?

PS One 120P and one VMC-100 are going to get Mach3 retrofit this summer and the other 2 we will leave them with original control.

Thank you
Daren
Canada

Similar Threads:

• Limit switches for axis(s)
• Taig Mill Limit Switches
• Do I need end limit switches on my Taig mill?
• Limit switches for XYZ axis
• Home/limit switches for small mill