- Need Help!- Emcoturn 242 w,TM02 cannot access R-parameters
-
Registered
Emcoturn 242 w,TM02 cannot access R-parameters
Hi, i dont know what im doing wrong but i cannot access the R-parameters in the MON meny. I can access the other parameters just fine but when i type R it says invalid parameter entered. The reason i need to get in there is because it suddenly out of nowhere gets a Z position of -20500. After reference on startup. Something is terrible wrong..
If anyone have any ideas please let me know. The encoder reads the position just fine. But the new Z-position will not let me run the axis due to the software limit being active.
Thanks.
Similar Threads:
-
- Need Help!- Emcoturn 242 w,TM02 cannot access R-parameters
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules