SODICK A530D EX21 4-AXIS

[systronic]

need help to run 4-axis on it

or good post for mastercam
or how to for run 4 axis on sodick a530d ex21

my post run good for regular cut & angle cut .....

my error on screen is : operating wire inclines code . z axis travel order si not accepyed

thansk for your reply

sorry for my english i talk french

[sodickappsguy]

i think the error that you are having is that after a certain date the sodick machines cannot move the Z axis with any other axis. (ex x.5 y.5 z0. will not work). Make sure your Z is on a line by itself and see if the machine alarms out. Only special controls with goverment permits are allowed to move the Z axis with any other axis now (LQ10W,LP10W,LQ34W,LP34W controls)

[royalblood235]

Hi Systronic,

I understand that you have a Sodick A530D EX21 machine.
There is any chance you could help me with an electronic copy of the Instructions Manual?
I inherited this machine, but I cannot find the manual.
I would really appreciate your help.
Thank you in advance.

Louis.