FANUC WIRE EDM OM CONTROL

[gabedrummin]

Hi all I hope someone can help ! I have a 1986 Elox modle O wire edm it has a fanuc OM control I am looking for parameters for it ...It has a over travle alarm x+ x- y+ y- all at the same time . Maybe bad servo driver bad parameters . I dont know. I would pay for these . Thanks for all your help

[duccnc]

Originally Posted by gabedrummin Hi all I hope someone can help ! I have a 1986 Elox modle O wire edm it has a fanuc OM control I am looking for parameters for it ...It has a over travle alarm x+ x- y+ y- all at the same time . Maybe bad servo driver bad parameters . I dont know. I would pay for these . Thanks for all your help

Are you sure it has Fanuc OM or 6M?

[gabedrummin]

Im sure the 6m used dc motors the om uses ac servos and drives a 6m has parameters to 400 or something the om has parameters to 8000. I have had a modle O with 6m a L with 6m this O is a OM control . Has red cap motors

[duccnc]

Originally Posted by gabedrummin Im sure the 6m used dc motors the om uses ac servos and drives a 6m has parameters to 400 or something the om has parameters to 8000. I have had a modle O with 6m a L with 6m this O is a OM control . Has red cap motors

The 6M can used the red cap motor.I am sure your machine is 6M with AC servo motor(red cap motor).Your machine model O is of series O/P/Q/R wirecut EDM.You can check it when boot up,on the screen display:
System 6M, Version ME....OK?

[gabedrummin]

The main pcb part number is a16b-1010-0210/04b this is what makes it a O control.....And my problem , someone cut wires in the control cabinet and I need a drawing . Everyone tells me it is rare to have a O control in there.....