536 Servo alarm Fanuc Tape Cut W1 Wire EDM 5Axis - CNCzone.com-The Largest Machinist Community on the net!

anoop.kp · #1 07-25-2008, 05:50 AM

Hi friends,

I m facing a problem in my Fanuc Tape cut W1 Wire EDM, When it is running an alarm 536, U axis Servo alarm is generated. For clearing this alarm i need to restart it and while starting again then i can see alarm 430 and an alarm on v axis pulse coder. i can reset this alarm by reset key and do homing again, but i m getting a difference in the homing by comparded to the last homing value, by this the job also getting spoiled. pls help me to resolve this problem.

With Regards
Anoop

anoop.kp · #2 07-25-2008, 01:34 PM

Any body can help me?

anoop.kp · #3 07-26-2008, 12:02 AM

Any body can help me?

anoop.kp · #4 07-27-2008, 12:25 AM

Hi friends,

I m facing a problem in my Fanuc Tape cut W1 Wire EDM, When it is running an alarm 536, U axis Servo alarm is generated. For clearing this alarm i need to restart it and while starting again then i can see alarm 430 and an alarm on v axis pulse coder. i can reset this alarm by reset key and do homing again, but i m getting a difference in the homing by comparded to the last homing value, by this the job also getting spoiled. pls help me to resolve this problem.

With Regards
Anoop

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
401 servo alarm fanuc 6t	ncprecision	Machine Problems, Solutions , Wireless DNC, serial port	9	04-25-2009 06:25 AM
Fanuc Drill Tape Mate 10 OM Alarm Problems w/ Pictures	howitt	Fanuc	9	11-20-2008 11:27 AM
alarm 408 servo alarm "serial not RDY", αP18 fanuc mtor code	sting	Fanuc	0	01-01-2008 10:03 AM
fanuc servo alarm	vpmachine	Fanuc	0	11-07-2007 03:33 PM
Fanuc Servo Alarm	herbmarkovit	Fanuc	20	11-20-2005 11:53 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)