| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| EDM Machines Discuss EDM Machines here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-22-2012, 01:31 PM
| |||
| |||
Hi I have some problems with my Sodick A 500. It's starting normally but after few seconds the voltage is dropping slowly down to zero and the machine returns to the startpoint, it's the same whitout water. It looks like a short circuit, but the machine is driving normaly in G00 without M05. So it can't be. If I change HP from 4 to 20 voltage is 150V, then it is going, but there isn't power enough to cut. The power is about the same level, as when I adjust the wire. Is there anybody who have tried the same, or know what could cause this problem?  |
|
#2
01-23-2012, 02:13 PM
| |||
| |||
| have you looked at your discharge cables? |
|
#3
01-23-2012, 02:48 PM
| |||
| |||
| Yes they are OK. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem in Sodick A500 nMark 21 | puneetchawla | EDM Machines | 1 | 03-02-2011 05:55 AM |
| Sodick AG600L | mconflict | EDM Machines | 2 | 12-15-2010 03:43 AM |
| Sodick Info | Paul Deady | EDM Machines | 5 | 11-27-2010 05:10 PM |
| Old Sodick 450, 600, 800 MC | Leha_Blin | General CNC (Mill and Lathe) Control Software (NC) | 1 | 02-14-2010 10:39 AM |
| MITSUBISHI FREQROL A500 INVERTER FR-A520-3.7K does anyone know if you can run 1 phase | CATCH22 | Phase Converters and VFD | 1 | 10-09-2006 12:19 PM |
| | |
Linear Mode
