Where To Ask For A Quote? - CNCzone.com-The Largest Machinist Community on the net!

cajun · #1 07-24-2011, 11:39 PM

Where would I post to ask for a quote on some cutting with a Laser,Water Jet, or Wire machine?It will be 1/4" AR steel plate.I need a steel that is hard so when someone hits rocks with the fish gig the point will not roll very easy.Does someone have another suggestion on a steel plate? Thanks for any input you might offer.Heres a couple of pics.

scadvice · #2 07-25-2011, 12:00 AM

Originally Posted by cajun

Where would I post to ask for a quote on some cutting with a Laser,Water Jet, or Wire machine?It will be 1/4" AR steel plate.I need a steel that is hard so when someone hits rocks with the fish gig the point will not roll very easy.Does someone have another suggestion on a steel plate? Thanks for any input you might offer.Heres a couple of pics.

...would be the fastest... how many are you talking about? No one will quote per part. It's all about setting up and programming. Then while it's setup... it's cost per part.

Steve

cajun · #3 07-25-2011, 12:51 AM

I won't need but 30-40 pieces at a time. Thanks for your input.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mfg quote	MBG	General Metalwork Discussion	15	07-30-2009 03:36 PM
Need a Quote	PK Floats	Employment Opportunity	2	12-02-2008 08:23 AM
Quote and Multi-Quote	JoBwan	Test Forum	0	02-23-2008 05:58 AM
Quote please	elmor fudd	Employment Opportunity	2	03-21-2006 04:58 AM
how to quote?	qmas99	CNCzone Club House	5	10-04-2005 01:55 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)