Mitsubishi wire type setting for zinc coated wire - CNCzone.com-The Largest Machinist Community on the net!

Futurewire · #1 01-25-2011, 09:35 AM

So, unfortunately the only options I have are. . .

0:BS
1:TN
2:SP
3:MD
4:HE
5:HF
6:SS
7:OM
8:HR
9:SR
10:MT

Any recommendations for which one to use with Zinc coated wire?

Royster · #2 01-26-2011, 03:47 AM

I'd be tempted to try them all to see if you get any differences.

However, sometimes zinc alloys can be refered to as spelter, so perhaps "SP" is the one to go for.....

HTH

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Charmilles 300 using Zinc coated wire problem	rtuls35	EDM Machines	1	02-17-2011 11:01 PM
Mitsubishi wire type setting for zinc coated wire	Futurewire	EDM Machines	2	01-25-2011 06:49 AM
Zinc coated wire	TheBigJW	EDM Machines	1	11-27-2010 11:56 AM
how hard it zinc coated rods to lathe	jpatz18	General Metal Working Machines	0	04-06-2010 08:39 PM
Wire EDM - Wire Type and Size	greenchair	General Metal Working Machines	0	06-17-2009 01:44 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)