Chermiles Robofil 290 connect to PC - CNCzone.com-The Largest Machinist Community on the net!

wasskii · #1 09-16-2010, 10:33 AM

hello

I'm newbie so be tolerant. My machine's working fine but i want to connect them to PC. I recently bought RS232-USB cable. but don't havy any idea how to cofigurate the machine and PC. There's written in manual to use TRANS3 soft but i can't find them. Also i'm looking for some soft to write programs for my Robofil on PC and simulate the process then using the connection sending them to machine.....

Thx for Your time

kip0569 · #2 09-18-2010, 01:24 PM

First thing is do you have a Charmilles or Fanuc control? They were made with both. If not sure watch the boot up sequence. That should give you some clues.

wasskii · #3 10-11-2010, 06:44 AM

i have Chermilles control. the should be exporting the file from DXF to ISO estension and then i can copy the file on my machine.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Charmilles Robofil 200 programs	Shawn Lucas	EDM Machines	9	04-02-2012 04:07 AM
Charmilles Robofil 200 startup	Shawn Lucas	EDM Machines	31	02-09-2012 08:34 PM
Robofil 310 (console 2)	Stiga	EDM Machines	24	09-13-2010 01:51 AM
robofil 290 problems	lathe_ratt	EDM Machines	2	05-18-2009 04:14 PM
Robofil 510	fruivo	CNC Plasma and Waterjet Machines	0	11-16-2007 10:03 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)