| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| EDM Machines Discuss EDM Machines here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-18-2010, 11:24 AM
| |||
| |||
Hello, I am looking for a good, low profile vise to go into a wire EDM machine. Preferrrably made from stainless, and it should open up about 12". Any ideas? Thanks, Mark Roberts  |
|
#3
06-21-2010, 04:56 AM
| |||
| |||
| Thanks for the response; I will check them out. Mark Roberts |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CNC Tooling | aaronn | CNC Tooling | 6 | 05-05-2009 02:59 PM |
| Tooling a Little Help? | Cartierusm | DIY-CNC Router Table Machines | 29 | 07-04-2008 09:38 PM |
| MT2 Tooling | desanctb | Canadian Club House | 0 | 06-25-2008 12:57 PM |
| What is Live tooling versus "non-live tooling"? | squale | General Metal Working Machines | 8 | 11-15-2007 02:38 PM |
| Where do you buy your tooling?? | 94vette | DIY-CNC Router Table Machines | 6 | 05-14-2006 11:30 AM |
| | |
Linear Mode
