Try going to ports and pins and checking or unchecking active low on z motor direction pin
My z axis is moving in the wrong direction.
After zeroing work -z goes up and +z goes down into work.
How can I reverse this?
x and y are also reversed.
Any help out there?
Similar Threads:
Try going to ports and pins and checking or unchecking active low on z motor direction pin
Thanks for the reply.
Unfortunately the software I am using (eding pc based cnc) doesn't give me options to change motor direction. It gives option to invert the jog keys direction. is this the same thing or is it just inverting the keyboard for easier handling?
Switch one pair of wires on the stepper drive.
Either A and A+, or B and B+.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I'm afraid I don't feel confident to do this as the wires are not labeled.
Thanks anyway
Thank you for your advice and the screen shot. I will try this. Unfortunately I have just had to send back my control unit to be repaired due to a problem with the running of the spindle so I will have to wait but your answer makes sense.
Cheers!