Edgecam posts to Share

[CAD122333]

Here are some posts that I am using with edgecam that I thought I would share with anyone who is interested, If you have any posts that you would like to share post them here.
If you have any questions About my posts let me know and I will do what I can to help.

This post is for a Haas super minimill
There is a G07 command with each tool change,on my machine i have made a program to move the table to a safe position every time there is a tool change Because there is limited space with this machine while using the rotary And is used evry time there is a G07 command
Here is the program

M05
M09
G40
G00 G53 Z4.4
G53Y0
G53X-16.
M99

A very simple program but I needed to put it in with every tool change and it was easier to asign it to its own G code and just type G07 instead.

If you want to remove th G07 command go to the code generator, Code constructors, Tool change, And remve it from First tool change,General tool change, and last tool change

[CAD122333]

Here is a post for a Haas VF 3 with a rotary head

[CAD122333]

Here is a Haas VF 4

[CAD122333]

Here is an untested post for a Haas lathe with poor graphics

[rider23]

...

[AiR_GuNNeR]

Thanks for sharing. What's the trick to getting the machine modifications to stick? I tried to change a post by changing the machine shape, saved it and compiled it, but even when I reopen the file, the machine is back to the original.
Thanks
Eric

[rider23]

What do you mean when you say machine modifications

[AiR_GuNNeR]

I change the shape of the machine in code wizard, saved it and compiled it, but when I select that post in EdgeCAM, it's back to the one it started with. Opening it in code wizard again shows the unmodified machine.

[Desmontut]

Hi

Anyone that has a graphic file for a Haas SMM 3 axis for edgecam post processor.

I would highly appreciate it.

/mille