Problem- V11.75 Tool Lib

[invs879]

I running 11.75 Edgecam.

Occasionally when starting a new sequence, picking the tool from my library, Edgecam does not retreive the tool description,comment,tool number, offset number from the library. All the dimensional stuff, and the feeds/speeds are retreived, but the sequence list does not show the desc/comment/tool#. My code generator needs this stuff.

If I start a new file, the problem goes away.

Any comments are clearly appreciated.

Thanks,

[jstikeleather]

This does not seem to happen in the latest release.

You are 4 releases behind, it could have been a bug that has been addressed.

Best of luck.

Regards,
Jeremiah Stikeleather

[howecnc]

I was working for an EdgeCAM reseller during the release of 11.75 and don't recall that being reported as a bug. Have you tried a fresh install?

[rayzer]

[QUOTE=invs879;656557]I running 11.75 Edgecam.

Clear all the fields in the Sequence tab Jobname, revision, programmer etc etc
This should help.

[invs879]

That seems reasonable. I'll look for references that have no value and clear them. As I said, if I open a new part the problem goes away. And the problem generally happens when developing new code generator or tweeking a process.

Thanks.


[quote=rayzer;657596]

Originally Posted by invs879 I running 11.75 Edgecam. Clear all the fields in the Sequence tab Jobname, revision, programmer etc etc This should help.