Tool store graphics

[rider23]

Dose anybody have any manuals for creating / editing tools or tool holders for the tool store? I would like to be able to change the way the offset value works on my milling tools so that the offset value is the length of the tool for the tip to the face of the tool holder and the gauge length is the distance from the gauge point on the mill to the end of the tool holder. this way I can measure how far the tool is out of the holder and my simulator graphics are accurate to what I am using on the machine.

[jstikeleather]

Hello,
Have you tried looking in the Edgecam User Guide? Specifically the 'Machine Simulation > Using Machine Simulation - Milling' section?

You should also look at the Edgecam Tutorials document in the section called 'User Defined Graphics Tutorial'.

These should be very helpful to you.

Regards,
Jeremiah