| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| EdgeCam Discuss EdgeCam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-01-2009, 02:29 PM
| ||||
| ||||
Is there a way to make my feedrate ramp up to speed in edgecam while facemilling? I am facemilling a part that is 49 inches long T1 material, I am using a mitsubishi cutter that feeds at 100ipm. when it first hits the part there is some chatter, but once fully under load (about 2 inches in)it settles down. I have already edited the program to do it manually, but just wanted to know if there is a way to do it in edgecam for future reference.
__________________ “The bitterness of poor quality remains long after the sweetness of low price is forgotten.”  |
|
#2
06-10-2009, 08:23 AM
| ||||
| ||||
| Try to edit your face milling cycle, go to the Lead tab, and at the top where it says "Percentage Feed", put 50 in there. The lead in move will feed at 50% of the feedrate on the General tab. This feedrate will be applied until the radius of the cutter is into the area that you are cutting. I hope this helps. |
|
#3
06-11-2009, 04:16 PM
| ||||
| ||||
| thank you 
__________________ “The bitterness of poor quality remains long after the sweetness of low price is forgotten.” |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Facemilling with x2 | Bluedog | Benchtop Machines | 5 | 02-25-2009 03:35 AM |
| Facemilling problem | Kevin Moore | Dolphin CADCAM | 6 | 07-18-2007 08:05 AM |
| Haas facemilling:coolant yes or no | joesimmers | Haas Mills | 16 | 06-15-2007 08:23 PM |
| Facemilling: 300 cubic inches per minute | Rekd | CNCzone Club House | 1 | 02-10-2005 10:51 PM |
| | |
Linear Mode
