Thanks for the bluescreen edgecam!

[kendo]

twice in a row this morning, I get bluescreened because I tried to delete a coolant function from the cam tree.

Same project both times, but I started from scratch after the first crash, then it did it again

BTW, every time I create an operation in the cam tree, I expand it and delete the coolant, spindle control, and define operation tabs
Is there a way to make this the default for operations since I never use those function in edgecam?

[ssoptical]

Call your re-seller, if you have the same one i do good luck getting a return call.

[tommy2002]

In Manufacturing Mode select: Operation-Preference.
In General Tab activate "Disable M-Function".
In Tooling Tab uncheck "Spindle Stop", and "Coolant Off".
Hit OK, and done.

[Mike Mattera]

I dont know why they leave that turned on. It just clutters up the tree. That was always the first thing I turned off in a new configuration.

Mike Mattera

[timf]

use cycles instead.
never like operations because of all the automatic junk