Problem- Edgecam 2009 Crashes

[fatboy-03]

I have installed Edgecam 2009 and am having problems with this release. I was currently using EC 12.5 with no issues. I have files that have two sequences in it to machine top side of a part then flip it over remove the clamping material and finish the second side. I have the PPF file and the NC file stored in the same folder on a network drive and I am using Job Reports which are stored in a diffrent folder on the same network. I can usually post one sequence with no problems but when I post the second sequence it locks up edgecam. I have tried turning off job reports but get the same results but if I copy and post to my local drive it dose not lockup and I am having no network problems. I have updated my post to the latest templet and re-complied and have re-loaded EC 2009 from scratch.
My tool library is on my local drive and below are my computer specs.
Is anyone else having problems with Edgecam 2009?

Dell Precision 6300M Laptop
4gb Ram
Nivida Quadro FX 1600 M Driver version 6.14.11.7575
160 gb hard drive with 120 gb free

[WayneHill]

We are have problem with 2009 V1 R2 SP2 opening previous versions. Most will open with no problem. Some open to 7% or 70% then lock up. Programmers get in a real pissy mood when this happens.

[Dan Petre]

Originally Posted by WayneHill We are have problem with 2009 V1 R2 SP2 opening previous versions. Most will open with no problem. Some open to 7% or 70% then lock up. Programmers get in a real pissy mood when this happens.

this has happened to us and we called technical support.
we were told to check the support folder for the toolholders (i think the *.meg files are to blame).
copy the old one over the new one.

[WayneHill]

Dan,

Thank you for the reply, but it turns out that it was a VPN firewall encryption setting between the buildings that was causing the file transfer problem. It had nothing to do with EdgeCAM. The firewall was picking on just the EdgeCAM files for some reason!!!

Our CNC programmers are happy today!

Wayne