CNCzone Network: RFQwork :: 3Dstuffzone :: Welderzone
Disabled "Lathe Index" command
In Edgecam 2009 I have vertical driven tool, Planar Milling mode and must use "Lathe Index" command but it is disabled (gray colored) with my Machine Tool tcp, however it is enabled with any other similar tcp.
May be something in Code Wizard file?
By widgitmaster in forum General Metalwork Discussion
Last Post: 02-26-2012, 07:23 PM
By walter in forum Epoxy Granite
Last Post: 12-02-2011, 12:45 AM
By tinkering in forum Mini Lathe
Last Post: 05-05-2011, 07:59 PM
By draftingrus in forum G-Code Programing
Last Post: 04-09-2007, 07:09 AM