EdgeCAM 2017 R1

[Xecus]

I can't find the info icon on setup after switch to manufacturing mode, although it was found in Edgecam 2016 R2.

Any ideas

Similar Threads:

• Edgecam 2016-2017 Impeller advanced 5 axis
• New CAM Feature of ZW3D 2017
• ZW3D 2017
• ZW3D 2017

[timf]

you dont have to "switch" like before.
select your machine by clicking "create sequence" then select the "machining" tab above that, select your tool and roll.

the tabs "setup-features-machining-NC code" are the toggles you are thinking of and they are more fluid now instead of on/off like it use to be

[Xecus]

you dont have to "switch" like before.
select your machine by clicking "create sequence" then select the "machining" tab above that, select your tool and roll.

the tabs "setup-features-machining-NC code" are the toggles you are thinking of and they are more fluid now instead of on/off like it use to be

your powerful note is like the magic key that make the info icon still available.

and that works on the new files but not applicable for old ones. is there any recommendations to make info icon appear on the old files?

[Vegabond]

But cant you just open the old files and do programming?