Edgecam Mach3 5 axis postprocessor

[Vegabond]

Hello!

Does anyone have a postprocessor for Edgecam - mach3 that is 5 axis?

Thanks, Robert

Similar Threads:

• Edgecam postprocessor for Tormach Mach3
• Help with postprocessor Edgecam - Mach3
• Need Help!- Mach3 postprocessor file for Edgecam 2014
• post Edgecam to Mach3 5-axis
• Mach3 postprocessor for lastest EdgeCAM

[MegaMoog]

Hello,

What set up are you using? I have compiled a specific post that I use for a B/C mini trunnion from Doughty Drive on my shark router. It took me a while to get it to do what I needed! But works for what I'm trying to do! Still tweaking it here n there. I'm using it as a 3+2 type for general positional indexing.
PM me if interested.

LJP

[Vegabond]

Thanks! but the edgecam sites inside he`s site ( Jeffcnc.....) is not working, and i tried to send him an email but the email doesn`t work...

[MegaMoog]

Robert,

This is the .cgd file from the post that I have made for my 5-axis machine. Start by taking a look n see if something can work for you? My machine is setup with "Y" gantry and "X" & "Z" attached to that. The "B" & "C" are setup as "Table / Table" motion.
As always be careful with any new post on your machine!

Let me know if you need some help.

Larry

[Vegabond]

Thanks!

You don`t have it for metric?

[MegaMoog]

Your welcome.

No, I do not have it in metric.
Maybe someday… ?

[Vegabond]

Some day you will! but i need to test it first, and i need to build an 5 axis