Using working post for Okuma LB3000ex, programming a C-axis turn operation that we use an endmill to cut some bosses on the OD of a cylinder.

Having issue where, in manufacturing environment, the tool (endmill mounted radial) renders in the correct orientation (radial), although the stock removed renders as though there were an invisible tool that was mounted axial.

The bigger issue is, i am unable to get the tool to even render in the radial position in the Simulator, it only renders it axial to the cylinder as if i were drilling the face.

Is this a problem with the set-up of the machine turret/mount in the post processor/code wizard or am i just not setting something correctly.

The code is fine and the part cuts great but i am unable to see the correct stock cut in the simulator.


Thanks in advance,

-PW

Similar Threads: