I am about to use all my ADHD-energy making the worlds coolest flyfishingreel. My hobbiemachine is an used Gildemeister 400 ctx, so I am very privileged:-)
Some years ago I was making the Backwinder Seatrout reel.
I am using Edgecam and codewizard for my turning programs.
My cnc control from Heidenhain need a description of blank and part profile to work. How can I make this separate in the start of the file?
Ehh.. I did indeed forget the P-word: PLEAS!!! any advises
This is about how I want it...:
T11 WT1 X100.0 Z100.0(CNMGR 08)
T5 WT3 X100.0 Z204.0(15.0 mm Jobber Drill)
*Here I need a description of a blank f.ex.based on a billet
N20 G20 X40 Z130.0 K2 Description of a 40mm round blanck
*here I need a description of the part
N50 Z-20 G34 : This line segment contains a thread
N50 G17 G21 G40
N60 G59 Z130.0 X0.0
N70 G701 X500 Z350
N80 G26 S3000
N90 T11 (CNMGR 08)
N100 G96 M4 S110 M15
N110 G00 X45.964 Z1.635
Last edited by Epikur; 03-23-2011 at 03:14 PM. Reason: Rudeness..