3 NEW KL-6050 MICROSTEP DRIVERS WITH C10 BREAKOUT BOARD ALSO 5VOLT POWER SUPPLY $150.

[heilcnc]

this package comes with
3 new kl-6050 drivers
1 new c10 breakout board
1 used but working 5 volt power supply (you need a bigger supply for your step motors!)
KL-6050 Bipolar Stepper Motor Driver Heat Sink is included.:
Supply Voltage 24 up to 60 V DCOutput
Peak Current: 1.5A,2.0A, 2.5A,3.0A,3.5A,4.0A,4.5A,5.0A
Step Modes: 1/2, 1/8
Suitable for 4, 6, 8 wires motors
Current Adjustment via DIP Switches
Over-Current, Over-Voltage & Short-Circuit Protection
i will send all documentation but you can also find it here
http://www.kelinginc.net this package would cost you $215 RESERVE IS $150 SO buyit now
for $150. plus $10.50 sh
http://cgi.ebay.com/ws/eBayISAPI.dll...sPageName=STRK:

[heilcnc]

.i will re list these please tell me why they did not sell are the 6050s no
good? this all cost me $215 all but 5 volt power supply new just $150

[heilcnc]

PLEASE TELL ME

[heilcnc]

PLEASE I NEED TO SELL THEM

[dertsap]

you'd be best off not using reserve prices , as soon as I bid on something and I see that the reserve has not been met I don't bid any further , at least if someone sees a realistic start bid then you'll have more luck , also you will probably make back most of your money if you split it all up
part of the problem is even if they haven't been used they will still come across as used goods with no support or warranty