NEW 3 AXIS DRIVER KIT FOR MINI MILL WITH KL-4030 MICROSTEP DRIVERS

[heilcnc]

THIS KIT CONTAINS 3 NEW: KL- 4030 Microstepping Driver, Heat Sink is included-Features of this driver * Voltage up to 24 to 40VDC, current output up to 3.0 A * Selectable resolutions, 1,1/2, 1/4, 1/8, 1/16, 1/32, 1/64 * Suitable for 4,6,8 lead motors * DIP switch current setting: 0.9A,1.2A,1.5A,1.8A,2.1A,2.4A,2.7A,3.0A * Over voltage, heat and short-circuit protection 1-NEW:KL-DB25 Breakout Board 1-NEW:KL-10-5 5V/2A 110V/220V, 50/60Hz-POWER SUPPLY FOR LOGIC NOT THE STEPPER MOTORS! PLEASE READ THE WHOLE LISTING THERE IS NO POWER SUPPLY FOR THE STEPPER MOTORS ONLY 5V FOR LOGIC ! SHIPPING USA ONLY!!!!!!!!!!!!!!
BIDING STARTS AT $150 $9.75 SH FLAT RATE http://cgi.ebay.com/ws/eBayISAPI.dll...PageName=STRK:

[heilcnc]

why did this not sell these are new keling 4030 drives iam selling them under
the cost they are $54.95 each the breakout board is new it was $24.95
the 5volt power supply was $9.95 must be no call for 4030 drives iam i asking to much? ($150)