Results 1 to 4 of 4

Thread: Intelligent Motion IM483 Stepper Motor Driver

  1. 02-24-2012, 10:36 AM #1
    MillworkMike
    MillworkMike is offline
    Banned by Moderators
    Join Date
    May 2009
    Location
    USA
    Posts
    133
    Downloads
    0
    Uploads
    0

    Intelligent Motion IM483 Stepper Motor Driver

    Intelligent Motion IM483 Stepper Motor Driver-im483.jpg




    Intelligent Motion IM483 Stepper Motor Drive CNC Router | eBay

  3. 02-24-2012, 07:01 PM #2
    MillworkMike
    MillworkMike is offline
    Banned by Moderators
    Join Date
    May 2009
    Location
    USA
    Posts
    133
    Downloads
    0
    Uploads
    0
    I also will be listing some IM805s in the next week or two if anybody is interested. :-)

  4. 02-27-2012, 10:34 PM #3
    MillworkMike
    MillworkMike is offline
    Banned by Moderators
    Join Date
    May 2009
    Location
    USA
    Posts
    133
    Downloads
    0
    Uploads
    0

    New Price!

    Intelligent Motion IM483 Stepper Motor Drive CNC Router | eBay

  5. 03-01-2012, 07:53 PM #4
    MillworkMike
    MillworkMike is offline
    Banned by Moderators
    Join Date
    May 2009
    Location
    USA
    Posts
    133
    Downloads
    0
    Uploads
    0
    Relisted!!
  6. Register to remove these Ads!

« Guhring Solid Carbide Straight Flute / Coolant through Drill Bit- 9mm - NEW | ACU-RITE Master MP »

Similar Threads

  1. Plz help me interface IM483 driver to parallel port
    By dondeaida in forum General Electronics Discussion
    Replies: 11
    Last Post: 08-10-2012, 06:10 AM
  2. Need Help!- Power Supply for 4 Stepper Driver 32-65VDC and 4 Stepper Motor 65V 2.3A
    By guy2b1 in forum DIY CNC Router Table Machines
    Replies: 16
    Last Post: 03-08-2011, 06:50 AM
  3. Need Help!- 6 leads stepper motor connect to TB6560AHQ stepper driver board
    By wf1318 in forum Stepper Motors and Drives
    Replies: 2
    Last Post: 07-25-2010, 03:19 AM
  4. Integrated stepper motor? with built-in stepper motor driver
    By uirobot in forum Product and Manufacturer Announcements
    Replies: 0
    Last Post: 06-07-2010, 04:59 AM
  5. Other stepper motor motion programs, not NC specifically?
    By Konstantin in forum General CNC (Mill and Lathe) Control Software (NC)
    Replies: 4
    Last Post: 01-18-2007, 06:14 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.