4 axis Taig DSLS 3000 listed on ebay

[mike_]

This is a 4 axis mill that's in like new condition. All that's been cut with it is a handful of wax rings for jewlery.


http://cgi.ebay.com/Taig-4-axis-CNC-...#ht_500wt_1154

[fretsman]

It may benefit you to put actual pics of your unit up for others to see instead of the stock photos. Especially since I believe the DSLS 3000 is different than what they are shipping after those photos were taken. For example, the relay box is different than what is shown, unless of course you have the older one.

Dave

[mike_]

Thanks for your input and you are correct, the box is slightly different but the truth is that the only different that a picture would show is that it has a different sticker on the front of the box. I believe the actual housing is the same as it was before. This machine is only a couple months old.

While I appreciate your input, I'm not going to take pictures unless someone with an interest specifically requests some. This machine is basically new and of the price I'm selling it for, I'm not super motivated to put forth much effort. The short story is that someone that wants one of these machines can save about $1000 by buying a machine that's cut a few pieces of wax.

None the less, thanks again for your suggestion.

It may benefit you to put actual pics of your unit up for others to see instead of the stock photos. Especially since I believe the DSLS 3000 is different than what they are shipping after those photos were taken. For example, the relay box is different than what is shown, unless of course you have the older one.

Dave

[universalfab]

Bet you wish you didn't buy that piece of garbage....