KFLOP KANALOG FADAL


Results 1 to 4 of 4

Thread: KFLOP KANALOG FADAL

  1. #1
    Registered
    Join Date
    Oct 2017
    Location
    United States
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default KFLOP KANALOG FADAL

    I'm retrofitting a 1999 Fadal 3016L with the following;

    -Fadal (analog +-10v) AC drives
    -BALDOR wye/delta analog Vector Spindle drive (with encoder for tapping)
    -21 tool geneva (non servo) ATC (MOTOR DRIVEN TURRET AND SLIDE)
    -PDI Bijur way lube system
    -Flood coolant
    -Thru tool coolant
    -E STOP (contactor type)
    -MPG with single ended encoder

    Will a KFLOP and KANALOG have the I/O to operate everything on the mill? I'm considering using Mach4 control software.... Is the KFLOP a good pairing with Mach4? Any tips or further information is appreciated.


    Chris

    Similar Threads:


  2. #2
    Registered
    Join Date
    May 2012
    Location
    canada
    Posts
    185
    Downloads
    0
    Uploads
    0

    Default Re: KFLOP KANALOG FADAL

    Hi Chris,

    I have a 94 Fadal 4020 running from Kflop/Kanalog. My drives are different so cant help you there, but all the outputs (toolchanger, spindle, oiler, coolant, chiller etc) on a Fadal are very easy to control with your existing 1100 interface board and Kflop. I can tell you which pins on the 1100 board control what as well. Ill post some pics of my setup later today/tomorrow.

    Personally i would reccomend you use KmotionCNC. Dont complicate things by using Mach. KmotionCNC will do everything you need to do.

    You will also need a Konnect board to handle all the inputs and outputs on a full function VMC. Good luck with it.

    Mark



  3. #3
    Registered
    Join Date
    Oct 2017
    Location
    United States
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default Re: KFLOP KANALOG FADAL

    Mark,

    Thank you for the quick response. I sent you a PM.

    Chris



  4. #4
    Registered
    Join Date
    Jun 2004
    Location
    Scotland
    Posts
    262
    Downloads
    0
    Uploads
    0

    Default Re: KFLOP KANALOG FADAL

    KFlop doesn't have a Mach 4 plugin, and I'm not sure what Dynomotion's current stance is on that.

    There is a Mach 3 plugin, but the supplied KMotionCNC is good and very reliable. It's even better now that you can edit screens.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

KFLOP KANALOG FADAL
KFLOP KANALOG FADAL