Need Help! How to Connect External Buttons in Kflop or Kanalog


Results 1 to 4 of 4

Thread: How to Connect External Buttons in Kflop or Kanalog

  1. #1
    Gold Member amitkumar171's Avatar
    Join Date
    Aug 2017
    Location
    India
    Posts
    56
    Downloads
    0
    Uploads
    0

    Default How to Connect External Buttons in Kflop or Kanalog

    Hi Everyone,

    I am using Kflop Controller. Now i have a requirement of adding 4 external buttons to same controller. And i can't find any support on that.

    I am planning to connect Emergency stop, Feed Hold, Cycle Start, Cycle Stop Buttons.

    So on which pin i have to connect these buttons on KFLOP or KANALOG. ?

    And after connection which C program to run for make external buttons work ?.

    it also helps others to make proper wiring on KFLOP Controller.

    Waiting for Positive response.


    Thank You
    Amit Kumar

    Similar Threads:
    Regards

    Amit Kumar


  2. #2
    Gold Member TomKerekes's Avatar
    Join Date
    May 2006
    Location
    USA
    Posts
    2513
    Downloads
    0
    Uploads
    0

    Default Re: How to Connect External Buttons in Kflop or Kanalog

    Hi Amit,

    Any input can be used.

    See the ExternalButtons.c example.

    Regards

    TK
    http://dynomotion.com


  3. #3
    Gold Member amitkumar171's Avatar
    Join Date
    Aug 2017
    Location
    India
    Posts
    56
    Downloads
    0
    Uploads
    0

    Default Re: How to Connect External Buttons in Kflop or Kanalog

    Hi Tom,

    Any input can be used.
    ok i connected my all 4 buttons to IO Bit 26, 27, 28, 29.

    See the ExternalButtons.c example.
    I have seen this ExternalButtons.c example. But how can i initialize this file. ?

    Should i include same in INIT file or i have to run it again and again.?

    or how can i include this c program into my INIT program. ?


    Thank You

    Amit Kumar

    Regards

    Amit Kumar


  4. #4
    Gold Member TomKerekes's Avatar
    Join Date
    May 2006
    Location
    USA
    Posts
    2513
    Downloads
    0
    Uploads
    0

    Default Re: How to Connect External Buttons in Kflop or Kanalog

    Hi Amit,

    Yes after it is working you can merge the program with your Init C Program.

    See:

    KFLOP C Programs - Dynomotion

    and

    KFLOP C Programs - Dynomotion

    Regards

    TK
    http://dynomotion.com


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

How to Connect External Buttons in Kflop or Kanalog
How to Connect External Buttons in Kflop or Kanalog