- Kanalog control of altavit31 vfd
-
Registered
Kanalog control of altavit31 vfd
Ativar31 has a 24 volt control for forward/reverse; can this be directly controlled by one of the FETs on the kanalog or must it be done indirectly with an SSR or relay(plus diode)?
Also 0-10 volts input from DAC should control speed (closed loop via quadature input)?
This seems correct just don't want to fry the board
Thanks in advance for insight.
Similar Threads:
-
-
Member
Re: Kanalog control of altavit31 vfd
You'll have much more luck asking this question on the Dynomotion forum. I'd be amazed if there were more than two people here who even know what a KAnalog is...
Regards,
Ray L.
-
Member
Re: Kanalog control of altavit31 vfd
Dynomotion team monitors this site on a regular basis. Tom will answer your question. Look at the specs on the FET on the Kanalog page of their site, clear safer to use SSR, so you won't have a chance to damage the Kanalog.
Tom is the expert he has all kinds of experience.
Russ
- Kanalog control of altavit31 vfd
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules