Kanalog control of altavit31 vfd

[oligocyte]

Ativar31 has a 24 volt control for forward/reverse; can this be directly controlled by one of the FETs on the kanalog or must it be done indirectly with an SSR or relay(plus diode)?
Also 0-10 volts input from DAC should control speed (closed loop via quadature input)?

This seems correct just don't want to fry the board

Thanks in advance for insight.

Similar Threads:

• Newbie- Dead kanalog?
• New Machine Build- KANALOG WITH MACH4
• Kflop with Kanalog board Question: Can I also control Steppers?
• Kanalog Questions
• KAnalog or Umax?

[SCzEngrgGroup]

You'll have much more luck asking this question on the Dynomotion forum. I'd be amazed if there were more than two people here who even know what a KAnalog is...

Regards,
Ray L.

[CNCMAN172]

Dynomotion team monitors this site on a regular basis. Tom will answer your question. Look at the specs on the FET on the Kanalog page of their site, clear safer to use SSR, so you won't have a chance to damage the Kanalog.

Tom is the expert he has all kinds of experience.

Russ