What if you add a M00?
Hi Guys,
Im trying to setup a few user buttons to load common tools and turn them on at proper speed to save setup time. For example click a user button to toolchange to edge finder and start spindle at 1000 rpm.
I have user button set to execute a G code program (just 2 lines, M6 T20, M3 S1000) but if I end with M02 or M30 the spindle stops after program finishes. And if i leave out M02 or M30 i get an error. Any suggestions?
Similar Threads:
What if you add a M00?
www.tsjobshop.com, www.homecncstuff.elementfx.com
Im not sure if its a good idea to have the program just stop and wait without finishing? I did try it out of curiosity and it seems to do the trick.
But is it a bad idea to just have that program waiting? Any suggestions Tom?
M0 Halts. Nothing is "waiting".
It should be fine.
Regards
Regards
TK http://dynomotion.com
Ok great, thanks again!