Motor current clamping


Results 1 to 3 of 3

Thread: Motor current clamping

  1. #1
    Registered
    Join Date
    May 2013
    Location
    Usa
    Posts
    211
    Downloads
    0
    Uploads
    0

    Default Motor current clamping

    I have a CNC set up by a friend and was intending to copy some of the board layout and wiring , but I noticed a possible mistake with the motor clamping

    My steppers are nema 23 at 2.8 amps and nema 34 at 6.3 amps

    My question is
    6.3 amps should be H,M, L, with clamps both sides of the coil....... correct or not ?
    And 2.8 amps Clamps on M, L , both sides of coil ......... correct or not?

    Thanks

    Similar Threads:


  2. #2
    Registered
    Join Date
    Jun 2004
    Location
    Scotland
    Posts
    253
    Downloads
    0
    Uploads
    0

    Default Re: Motor current clamping

    Correct on both counts.



  3. #3
    Registered
    Join Date
    May 2013
    Location
    Usa
    Posts
    211
    Downloads
    0
    Uploads
    0

    Default Re: Motor current clamping

    Thanks



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Motor current clamping
Motor current clamping