- Motor current clamping
-
Member
Motor current clamping
I have a CNC set up by a friend and was intending to copy some of the board layout and wiring , but I noticed a possible mistake with the motor clamping
My steppers are nema 23 at 2.8 amps and nema 34 at 6.3 amps
My question is
6.3 amps should be H,M, L, with clamps both sides of the coil....... correct or not ?
And 2.8 amps Clamps on M, L , both sides of coil ......... correct or not?
Thanks
Similar Threads:
-
-
Member
Re: Motor current clamping
-
Member
Re: Motor current clamping
- Motor current clamping
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules