Hey Thanks All for you replies,
I've got an initial problem powering up my Servo, clearpath tecnics motor.
I get an error "automatic disconnect" when I plug in my ribbon cable to my single test motor. I looked up this error and it might have something to do with my kflop, J7 5+ v out to my motors pin to initalize. The motor needs 5+ volts to active it's onboard electronics and I have the digital ground pin going to the Motor's 5- v, the other pins. I'm not sure what Digital Ground means actually.
So the other pins from the J7 Kflop are to (STEP) 15,17,19,21 and (DIR) to 16,18,20,22 going to (motor direction) pin 3 and (motor Step) pin 4.
Kflop J7 23 +5volts out is dasiy chained to all motors pin 4, the ENABLE + and
Kflop pin 25 DIGITAL GROUND daisy chained to to all motors ENABLE -.
Looks like one of the voltage supply pins was getting grounded out... oops.