KmotionCNC 4.34H, init question


Results 1 to 3 of 3

Thread: KmotionCNC 4.34H, init question

  1. #1
    Registered
    Join Date
    Jun 2005
    Location
    USA
    Posts
    1308
    Downloads
    0
    Uploads
    0

    Red face KmotionCNC 4.34H, init question

    I have a question, when we run the kmotion software we have an init.c file that setups up the axis for Velocity, Acceleration, etc.

    When you run KmotionCNC, there is a trajectory tab under the Tool Tab, there is the axis setup info as well with Velocity, Acceleration, etc.

    When running KmotionCNC does it uses the settings in the trajectory tab? Or do I have to change them in the init.c program as well.


    Russ

    Similar Threads:


  2. #2
    Gold Member TomKerekes's Avatar
    Join Date
    May 2006
    Location
    USA
    Posts
    2418
    Downloads
    0
    Uploads
    0

    Default Re: KmotionCNC 4.34H, init question

    Hi Russ,

    Both are used. Please see this article:
    http://www.dynomotion.com/wiki/index...on.2C_and_Jerk

    Regards

    TK
    http://dynomotion.com


  3. #3
    Registered
    Join Date
    Jun 2005
    Location
    USA
    Posts
    1308
    Downloads
    0
    Uploads
    0

    Default Re: KmotionCNC 4.34H, init question

    Thanks Tom, just what I needed, not a little more playing.
    Russ



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

KmotionCNC 4.34H, init question
KmotionCNC 4.34H, init question