Dynatorch XLS Cutting/Hypertherm 85 Examples

[chemosavi]

Thought to post some examples of what the Dynatorch XLS accompanied by the Hypertherm 85 does in terms of cuts for a week old owner.
The stainless is .5" 304 and the bronze is .1" thick cut with fine cut consumables. Cut speed with the 1/2" was around 27-30 ipm but could have been slower to achieve more precision. Definitely not the table's fault as evidenced by the bronze.

Similar Threads:

• hypertherm 1650 cutting IDs first?
• Oxy fuel cutting on Dynatorch
• Hypertherm turning off when cutting 9mm
• Air Compressor Help for Dynatorch w/ Hypertherm PowerMax 1250
• Dynatorch Height During Cutting

[CNCCajun]

Thanks for posting . . . what do you think caused your holes in your 1/2" to be a little out of round, or is that just the way it looks in the picture. Would speed cause that?The bronze cuts looks really clean.

Again, thanks
Steve

[chemosavi]

Cutting holes in 2" x 3" tube

[DynatorchAfrica]

Do any of you use a water table? I'd like to know the type of anti rust solution that works best.