- Dynatorch XLS Cutting/Hypertherm 85 Examples
-
Registered
Dynatorch XLS Cutting/Hypertherm 85 Examples
Thought to post some examples of what the Dynatorch XLS accompanied by the Hypertherm 85 does in terms of cuts for a week old owner.
The stainless is .5" 304 and the bronze is .1" thick cut with fine cut consumables. Cut speed with the 1/2" was around 27-30 ipm but could have been slower to achieve more precision. Definitely not the table's fault as evidenced by the bronze.
Similar Threads:
Last edited by chemosavi; 12-17-2013 at 08:57 PM.
-
-
Registered
Thanks for posting . . . what do you think caused your holes in your 1/2" to be a little out of round, or is that just the way it looks in the picture. Would speed cause that?The bronze cuts looks really clean.
Again, thanks
Steve
-
Registered
Cutting holes in 2" x 3" tube
-
Registered
Do any of you use a water table? I'd like to know the type of anti rust solution that works best.
- Dynatorch XLS Cutting/Hypertherm 85 Examples
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules