| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| DynaTorch Discuss DynaTorch machines here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-05-2010, 11:04 AM
| |||
| |||
Is anyone running the friction test that's built into the DT software? Just curious what kind of results you are seeing. On my long axis I got a pretty consistent reading of about 0.6 all the way down and back. On the short axis it varied from a low of about 0.4 up to a peak of about 1.1 at one spot near the center. Measured across the linear rails and found they were just slightly out of parallel, trued them up and got the friction test reading consistent all the way across. I never checked to see if I could feel a tight spot moving it by hand and don't know if this will make any perceivable difference but I'm sure it won't hurt.
__________________ www.modernironworks.com  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Friction - tight 5 start acme nut | CountyK | CNCzone Club House | 7 | 10-18-2009 09:34 AM |
| Coefficient of Friction | TZ250 | Mechanical Calculations/Engineering Design | 2 | 06-28-2008 11:59 AM |
| Friction welding | Geof | Welding, Brazing, Soldering, Sealing | 7 | 08-08-2006 02:51 AM |
| Friction Co-efficient of Air | Al_The_Man | Work Fixtures and Hold-Down Solutions | 8 | 04-05-2006 12:22 PM |
| Problems with friction and .. | Nikolce | Linear and Rotary Motion | 0 | 06-14-2005 01:37 PM |
| | |
Linear Mode
