Newbie Converting plasma table to waterjet - CNCzone.com-The Largest Machinist Community on the net!

Shrimp · #1 03-19-2010, 09:24 AM

We have a 6x12 plasma table with a Kaliburn 150 amp and Dynatorch table.

What would it take to convert this over to a waterjet? We have recently found some work that requires no heat to be transfered to the material as it is a high pressure flange.

magma-joe · #2 03-19-2010, 12:12 PM

Contact Dynatorch, they recently came out with a retrofit Laser setup for their tables. They might be able to help with the waterjet also.

Magma-joe

Shrimp · #3 03-19-2010, 12:15 PM

Thanks Joe!

JakeM · #4 04-14-2010, 01:29 PM

Wardjet use to make a retrofit kits for plasma/oxyfuel tables and mills. Not sure if they still make them or not.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
A Guide: Plasma vs Laser vs Waterjet vs EDM	InspirationTool	CNC Plasma and Waterjet Machines	25	07-20-2009 01:43 AM
Newbie- Convert Plasma to Waterjet?	mblock68	CNC Plasma and Waterjet Machines	9	06-14-2009 08:43 AM
Best CAD/CAM Software for CNC Router, Plasma, WaterJet	exit63	General CAM Discussion	1	10-20-2007 02:58 AM
General - Plasma vs Waterjet and pricing	Metalmog	CNC Plasma and Waterjet Machines	1	09-17-2007 01:05 PM
waterjet or plasma CNC for homebuild	Goldhunter_2	CNC Plasma and Waterjet Machines	6	07-13-2005 06:28 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)